Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I want to increase or decrease the volume of my circuit digitally. So anyone can suggest me which technique I can use for that. If anyone knows any digital pot which works on low power please help me in that also.
Switch takes 10mA of Current and it takes 5ms to contact bounce so how much current it consumes in 1 press.
also led takes 30mA forward current with power dissipiation 100mW so how much current it takes for glowing 1 to 3 Sec.
How could I know duty cycle for all of these?
I'm using 3 Alkaline batteries()3450mAH to power my circuit, In my circuit Microcontroller consumes 300uA Current in active mode and 0.1uA current in power down mode and RF IC consume 11.5mA current in supply mode and 1uA current in shutdown mode so I want to know how much power my circuit...
I want to design a 433MHz RF Transmitter so I want to know which protocol should I use for data transmission from transmitter to receiver. & How can I packetized my data in well format.
Hello sir
I am working on one of the RF based project in which I have to connect number of RF Rceciver modules to the Single RF Transmitter Module so my question is that is possible or not. and how many Receivers can be connected to a single RF Transmitter module. If it is not...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
