Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi KlausST,
Thanks for your response.
I am getting voltage at IC across the divider as 267mV. So i think there is a proper AC signals.
My Configuration is as follows.
Shunt 2m Ohm and LLine Configuration.
Software Configuration
REG_CALBR_START written 0x5678
REG_CHECKSUM1 ( 0x2C )- read and...
Hello,
I am using the same chip ATM90E26 on a custom board. The board is working fine , as there is proper communication between the IC and the micro-controller. I am able to read and write into register.
In the application note it is mention that frequency, phase angle and power factor...
Hi,
I am using ATM90E26 on a custom board and able to communicate with it using Uart with baud 9600.
For the calibration purpose, i am following atmel application note mention here:
http://www.atmel.com/Images/Atmel-46102-SE-M90E26-ApplicationNote.pdf
After calibration, I am getting frequency...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
