Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
lan9115
Hello,
I have a problem with DMA burst transfers when communication is between Cyclone 2 FPGA nad SMSC LAN 9115.
I have a common bus sharing for SRAM and LAN 9115.
The problem is that ,when i get an interrupt from the LAN device i read the data from LAN FIFO and put in a temporary...
reading data from ade7754 spi
both are differnt softwares they have to be used for differnt purpose.
calibration software is to calibrate the meter just check out the procedure to calibrate the meter. the doument comes with the CD.
what are the connections to be made for SPI connections between two PIC microcontrollers(18F4620). one is master and other is slave. what are the connections are to be made apart from SPI pins? Slave select or Chip Select?
what are bits to be checked for transmitting and receiving the data...
hyperterminal spi
hi
i have data that has come form SPI and i want to display on Hyperterminal.....
i am grtting the data correctly in the serialBUF but when i put this data on the Serial POrt i am not getting those values i am getting some Junk....
i am using PIC 18F4620 and C18 Compiler...
hi,
iam using PICDEM LCD board with 18F8490 controller.
i am not able to put data in LCD. the democode they gave is perfectly running.
and the documentation they dont nt have much details of LCD or it pin outs.....
has any one earlier worked on the same before?
if any one has sample code in C...
Printer connections
hi
i want to connect a printer to the PIC microcontroller
the driver circuitary has 26 pin FRC Cable. how do i conect it to the PIC?
i have attached the document
akhileshchidare
ade7754
hi
Did u start working on your project?
have you calibrated the ADE7754?
its not only you have to perform the read operations from the microcontroller...but calibration should me done thru the microcontroller as the end product may or maynot have PC.
reading the registers from ADE...
hi sadashiv,
i have these documents. the problem here is the compenents which you are seeing in the driver circuits are not available in INDIA. So i need the components equivalent to these which are available in india. Can u help me here?
Akhilesh Chidare
m190g printer
hello ,
i am also worj=king on the same printer but i am not able to find the components of the driver circuit.
where did u get the Controller Board?
can u tell me where the controller board is available?
it will be very helpful for me.
thanx inadvance
Akhilesh Chidare
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.