Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
All i know is that Port 0 has open drain output drivers so the pull-ups must be provided externally.
Ports 1, 2, and 3 have built in internal pull-ups.
But my question is why only 10k ohm resistors are to be used why not some other value?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.