Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI,
i am designing a simple PCI I/O card. i am stuck with some problems. i just want to switch relays on that I/O card. i am using PLX 9050 chip. my i/o cards r working in the slave mode .. always
Querries:
1- How can i use chip select.
2- i have to access I/O address space but is there a...
Re: +cme error : unable to get control of the required modul
hay man !!!
I'm very thankful to for your Help !!!
it did worked for me ....
Thanks once again ....
-with regards,
-airian73
Hi guyz !!! im a newby in Modems.
I designed a board for gsm/edge modem
Mobidata MBD-10E
but when i connect it through Serial Port (with Hardware Flow control) it keeps re-intialiazing it self lyk this
+ CFUN : 1
+ CPIN : Ready
//after a few seconds* again
+ CFUN : 1
+ CPIN : Ready...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
