Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have recently made a Tesla coil using this schematic: and I’m having problems. The secondary coil is roughly 900 turns of 30awg magnet wire and the secondary is 8 turns of 14awg wire. The only difference from mine to the schematic is the 50kohm resistor was replaced by a B50K potentiometer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
