Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
I have this soldering station on AT89C52 schematic , But there is this little problem over here.
My thermocouple readback does not corresponds to my Set Value of the soldering station.
I am a little weak in electronic component.
Situation :
I set my SET value as 200 and it does not...
Hi all,
I encounter the proteus keep exiting the program after when i upgraded to version 7.10 ?
Anyone encounter this trend before... ?
Anyone has any suggestion or method to share with me ?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.