Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I would recommend starting with the RF System DesignGuide in ADS. From any schematic, select DesignGuide > RF System > RF System Tests and Basic Modulation Types.
Re: loadpullpres.ppt
If you are using ADS for load pull simulation, we have recently updated the Load Pull DesignGuide. If using ADS 2009 Update 1 or earlier, you may download a version of the Load Pull DG from the Agilent EEsof Knowledge Center...
You change the class of operation by adjusting the bias and input signal amplitude such that the conduction angle is reduced. In Class A, the conduction angle is 360 degrees, meaning that the device is on for the full cycle of the input sinusoid. You can shift the bias point such that it is on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.