Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for reply.
I want to ask some very basic question.
1) How to choose the DC input cable thickness?
2) How to choose Fuse current/voltage rating at the input side?
Vin = 10-14V
I max = 60-75A
3) Is it possible to have reverse polarity protection at input side?
Regards
Thanks for reply,
I want to make a low cost simple DC/DC converter and also need high efficiency. I can use any topology which can handle the required power. I just want to learn how power electronic design works.
Regards
1621236194
I need isolation because i want to work with TL431 with...
Hi,
I want to design a high power isolated PushPull converter. Specs are as follows.
V(in): 10-14V
V(out): 120VDC
P(out): 600W
Eff: >85%
I need some material for reading. Is it possible to achieve ZVS for push-pull converter ? What is current feed inverter?
Which PWM controller should is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.