Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Simulation of metal oxide metal diode
Hello there,
we r trying to simulate MIM diode using 4 nm of oxide layers but HFSS gets stuck on meshing....What I mean to say is that it is unable to mesh the structure...Can you please tell me how did u simulate a 5 nm oxide layer in HFSS? I mean...
hello I am trying to look at your design. however since you are exciting using two ports what is the reason for this? can this be modeled using single excitation? this brings to me the parallel plate capacitor , it is easy to model using a single port excitation but I could not model using two...
hi excitation is done to the parallel metal plates. first in solution type use driven terminal model. after this you can put a rectangle sheet such that it touches both the metal plates and then you can use "lumped port" excitation by right clicking on the rectangle. assign excitation- lumped...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
