Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes, I saw the data going in from the PIC is correct (I checked it using a CRO), So data recieved by the chip is correct.
Does anybody know how to use the FT_Purge() function what is the Umask in that?
Thanks
Re: FTDI 2232 H Mini Module SPI to USB converter Clock Probl
i apologize if i am not able to make myself clear.
The problem is the free or ideal state of the clock is high (b/w ftdi and MCU).But as soon as i intialise my program the clock immediatly goes to low and then starts the clock...
Re: FTDI 2232 H Mini Module SPI to USB converter Clock Probl
Hi
But the problem is with the ftdi chip and its clock mode. I cant seem to make it start from high in the operation too.. that way it wont go to low and MCU will misread it.
Sorry, I dont understand how the bit reversal register is...
Hi
So I am trying to send data from SPI bus (from PIC MCU) to USB. I was using the MPSSE protocol and was able to do it .
The problem i am facing is that to run the program successfully , we have to restart the PIC MCU. The reason behind this is as soon as the program gets executed , the CLK...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
