Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have been trying to design the cantilever beam in 3D MEMS module,
but always come an error crops up i.e:
"No convergence achieved.."
Is there a problem with the amount of force I apply at the edge or mesh resolution or something else?
**Also, How do I vary the thickness and observe the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.