Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Wp100 yes it worked and I am now able to program F1825 chips with ease using the MPLAB v8.92. I have not downloaded the Mplabx because I didn't feel the need for it yet. But may have to download it for other PIC18 series chips. Thanks again.
C Program does not work when ported from PIC16F688 to PIC16F1825
I've been working on a CCS C program which read temperature from DS18B20 device and displays it to the LCD using sprintf statement. While my program works like a charm on PIC16F688 but once I upgrade the chip to PIC16F1825 it seems...
Wp100 Thanks for your suggestions. Here is what I have tried so far:
Successfully programed a PIC16f688 device with the PICKit3. Was able to erase and then load the hex file into it and that hex file functions correctly with its board, and BTW I am using the stand alone software that came with...
I have just purchased a clone pickit3 (ebay) and have tried to program PIC16F1825 chip.
It does not program at all. Blankcheck reveals that it did not program.
I have used MPLAB v8.0 to v8.86 without any luck. I also tried to use the standalone software that came with the PICKIT3 but it does...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.