Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
greetings, i have designed my own ZMPT101B to detect AC voltage, but I got some problem with reading the signal, here's the waveform using arduino plotter
does any one of you know how to only detect VPP of the signal ?
so it means I can give the high side MOSFET the SPWM and the active low side with only 50Hz square wave ?, that make sense actually, I'll try it for sure
greetings, I have built an H-Bridge circuit and using IR2113 to drive the high and low side, I've created an SPWM lookup table for my microcontroller to feed SPWM signals to LIN and HIN, here's the signal, blue is HIGH side MOSFET gate signal and yellow is LOW side MOSFET gate signal, Vgs of the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.