Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
problem with void main
hello everyone..
i need some advice for my project.
my project now is in final stage..
i think my problem is in the main program..
when i press the start button,
the robot move nicely.
but when i press either the right or left button,
the robot is not move.
here i...
Servo Problems
Hi everyone..
i still need your help about my code in mikroC.
my problems is when i run the simulation using the ISIS ( Proteus),
1st servo automatically run.
in this code,
i declare the start button,
where i should activate the start button first,
and then the servo will...
Re: Interrupt Problems
sorry my friends because don't reply this topic.
actually,
this problems related with my previous post.
what i want to do is to create 3 angles for 1 servo motor,
which are -90,0,90.
in my project,
there are 3 servo motor.
for example,
servo1 will turn 90,
servo3...
Re: Interrupt Problems
Thanks Gomez..
i'm so sorry that i not respond to your post before.
i had a problem with my computer..
I will try it & inform to you later..
thanks..:D
Added after 13 minutes:
sorry gomez,
i really confused & no idea how to write it.
this is code that I try.
Re: Interrupt Problems
I already define the port.
but now,
there are problems at this point:
init_v();
what command should i put.?
sorry for my question..
Re: Interrupt Problems
Is this command for CCS..?
Basically,
I use mikroC..
sorry if don't mention it before..
now,
I just try to change it to mikroC command.
Re: Interrupt Problems
anyone else..
plz help me..
is there any solution to create an angle of servomotor..?
in my problem,
i used 3 servomotor.
each servo will have 3 angle.
now,
i had try using the interrupt,
but it can't run properly..
www.ermirco.com/blog
hi all..
i need some help about my code.
hope all the members can help me to solve the problems..
i'm using :
MikroC,
PIC16F877A,
3 servomotor.
my problems is:
the command for servo1pos3() is working,
but the program is not move to the next step which is command for...
hexapod walker
Hi gang..
i'm new here.
nice to meet u all..
actually,
i need some advise from other about my project.
as i mention,
my project is about hexapod walker.
this robot using 3 servo motor & PIC16F877A with 20MHz.
my problems is to create the signal for this servo motor.
each...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
