Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello Ajit
Were you able to solve the calibration procedure using arduino? I am looking at using the ade7816 with a rogowski coil and arduino via SPI to monitor weld current for a spotweld process. Any advice would be greatly appreciated.
Regards
Aidan
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.