Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello again, sorry for the delay and once again thank you for the reply!
Well, it seems I messed up. I forgot to connect pin 6 to ground every time when I ran without the MOSFETs. :lol:
When I built the complete circuit as suggested this problem was solved and it now works fine. I took some...
Thanks for the replies! :smile:
Hmm, interesting thought. I did now reset the oscilloscope (Rigol DS1052E) to factory settings, but I'm still getting the same issue. Channels are set to trigger on rising edge. Since I'm using the same time base for both channels I guess this should not be the...
I have tried with a couple of those driver chips and also with different values on the timing components in between. The result is always the same, two signals basically in phase with each other. I also have a voltage regulator on the Vcc pin not to damage it by over voltage. I've also scoped it...
Hello,
I'm trying to design a switch mode power supply (half bridge configuration) as a hobby project. To do this I centered the design around the IR2153D circuit, please see datasheet here:
http://pdf.datasheetcatalog.com/datasheet/irf/ir2153.pdf
The design I'm trying to follow is basically...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
