Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Not only the PCB is costly,
also soldering the chip is more and more difficult.
Now even with lower pin number, the packages have very fine pitch.
Furthermore, modern FPGAs need several supply voltages,
some are very low but must be of very low resistence.
This is difficult to do, and until...
Re: CRC calculation problem
I have worked on CRC methods recently.
I would recommend you the following:
start with data, which contains just a single '1', all other 0.
This should give you a hint of what goes wrong.
You should consider, that both methods you described, SW and HW work
with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
