Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What you said makes sense, because if the voltage is twice as high then the amps must be 1/2 of it.
That website helped out quite a bit.
I think I am going to put in DC and run it through a 555 timer and a couple of other things and convert the pulsed DC into AC once it goes through the...
Actually it is already built but I don't know how to get the input I am looking for.
The purpose is to just put high frequency AC through it and see what comes out of the secondary. I know that a air core will lose all kinds of flux but that is not a concern. I just need to put very low amps...
I am trying to build an air core transformer. It must operate between 900khz and 1.2mhz. I would like the input to be as little amps as possible (.01A) and the voltage to be up to 250. I know how to read a basic schematic but am not sure on the specifics I need to build it. I already have the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
