Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
felix c-256
Hi All,
I am in need of the assembly language instruction set / programming model of Felix C-256 computer or ASSIRIS. I would be extremely grateful for any info in this regard.
Regards
Abu Zafar
thermal head signals
I found a thermal printing mechanism from junk. There is no marking on the thermal head. It is 57mm wide. The controller PCB (out of order) has following 14 pin connection designations at thermal head connector.
1. GND
2. TM
3. STB1
4. LAT
5. CLK
6. 24V
7. 24V
8. 24V
9...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.