Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Please find the attached that I want to make my pulser board by using ultrasonic
1MHz up to 20 MHz (Tx-Rx in one)probe and I have problem with
Tail of ultrasonic signal is too long then I can’t measure thickness of material which
have very thin wall thickness please see my question below
-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.