Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey guys,
Q-factor is proportional to the ratio of dielectric constant/substrate height.
But, BW is inversely proportional to Q-factor. Then increasing substrate height decreases Q, implies BW will increase.
Hello guys,
I needed help, i want to plot the relation between Q-factor and substrate height, h, and patch width, W, for the RMSA design.
Because, i have used "Lowering Q-factor" technique to increase the bandwidth of conventional RMSA. I have achieved this by increasing the h and W.
But i want...
Hello Guys,
I need someone who has designed CPW patch antenna. I want to design this type of antenna and microstrip antenna with enhanced performance and will them in my thesis.
The problem is how am i going to design and simulate CPW patch antenna. I can't find clue how to begin with...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
