Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how to make virtual serial port using soft serial library in arduino 1.0 IDE.Actually i am able to send from arduino UNO to GM862 QUAD but
there is no response from GPRS module.can i get source code for making virtual serial port using softserial library whcih is available in Arduino 1.0 IDE.
Thank you very much sir for reply...
Now i am using below link to connect my GM862 QUAD module.
https://tinkerlog.com/2009/05/15/interfacing-arduino-with-a-telit-gm862/
but i am using ARDUINO UNO module
I am not using any voltage divider circuit for this and i am not getting any response.Message...
I have breakout board . But how to sent command from Laptop having ubuntu operating system
I have already searched a lot , everywhere is information about AT command set but my problem is how to use these command to check my device is working or not,where to write these command? is it on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.