Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
pic16f877 gps
Thnx man you ROCK!!... i realy appreciate it bud..
now i connected the PIC (Rx pin) to GPS as the GPS is only a transmitter... i need the PIC to receive the NMEA message from the GPS (in text mode).. here's the code:
Code:
Usart_Init(19200) ' Initialize USART...
mikrobasic usart con 16f877
Thnx man you ROCK!!... i realy appreciate it bud..
i'm afraid that's not just about it!!.. :D
now i connected the PIC (Rx pin) to GPS as the GPS is only a transmitter... i need the PIC to receive the NMEA message from the GPS (in text mode).. here's the code...
usart_read_text
hey guyz...
i'm interfacing a GSM modem (seimens gsm35) with a PIC16F877.. connected the modem to the USART bus of PIC... i need to send an sms from my gsm.. i wrote this code in microbasic but there's a couple of stuff that i'm not sure about... would you please check my code...
at-commands list
hey guyz..
i'm a newbe at AT commands.. configuring a TC35 GSM modem.. i need to know if i can configure it to recieve the data from the serial interface and send it as SMS??... if it is possible what commands should i be using to do so??.. now the data is coming from a GPS...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
