Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I designed a voltage doubler rectenna using qucsstudio free simulation tool. Since it is a bit more manual than ADS (with equally amazing capabilities nonetheless), there is need for extra input on the data display in terms of syntax to give you the graph you need. I have obtained the S11 and...
Re: using CST to design PIFA to work at 2.4G, getting bad result
I actually am designing this based on dimensions I got off of a thesis done previously. I have seen the design formulae and how he obtained the dimensions. Both shorting plate and feed were at the edge of the substrate as I did...
Re: Yet another amateur PIFA designer
Thank you for the observation. I stripped down the outer layer down to ground plane as suggested (please see result). Am I not supposed to get a nice dip at 2.4GHz like I got for my microstrip patch?
Hi guys!
These days one must start by apologizing to post a perhaps redundant question, academia churns out new amateurs each day! This is not to say that I have not looked through (and used) some of the numerous suggestions on here.
That being said, I am in the process of designing a PIFA...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.