Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
accoring to the firmware i send reprt
if(Read_buffer[0] == 2 && Read_buffer[1] == 2 &&
Read_buffer[3] == 2)
and send data to port B
PORTB = Read_buffer[2];
SO I USE CONTROL OUT WITH ARRAY BUFFER FROM (0 TO 3) TO SEND REPORT 2 2 2 AND DATA 255
Hello,
I am developing usb interface using pic18f4550 with micro c that just on and off LEDS and it works well with visual basic,but when I try labview VISA RAW as the control program the circuit does not respond
I tried all the examples in ni website USBRawBulkMain , USBRawControl...
Hell Everybody,
I am still doing expirements about usb interface with pic18f4550
first using visuall basic and it works successfuly.
but currently i am using labview and it works fine for one device
but if i connect to devices with the id's
vid_1234&pid_0001 for first pic18f4550 and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
