Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi I want to make new project for wireless power transmission.
on the secondary coil I want to receive 200 watt 12 volts.
the air gap is only 1cm.
I need documents or website for calculations.
thanks
1679568447
actually I cant Make a union to overlap the float with enough bytes
In Codevision It's only able in integer or long integer variable types
My circuit consists of atmega8A , 16x2LCD ,increase button and decrease button
my code is an example about convert float value to integer value (I need this function to write float value on serial EEPROM)
the problem is that when use (int) structure, the result always less by 0.1
that problem...
My project is control of Muffle temperature by stable temperature rate rise .
I use Atmega64 , thermocouple temperature sensor, 1800 watt heating coil (8A at 220 V AC).
The driver circuit can change the current of heating coil by Accuracy 0.08 A (in the program code the set value changes from 0...
I changed R23,C18,C20,R25,C26 and the result became a little bit better.
While thermocouple input shorted to GND and after installing the AVR ,the ADC0 voltage became 45mv.
I tried many times ,but I can't remove this 45 mv ,finally I readjust the offset potentiometer(R1) to make ADC0 equal...
this is my design for Thermocouple K-type amplifier
The output (TC) of amplifier circuit is connected to ADC0 PORT of ATMEGA8L
At first : To calibrate the amplifire (LT1012) I remove the microcontroller then I short the Thermocouple input to ground , then I adjust the offset
potentiometer(R1)...
Re: ESP8266,ATmega8,Temperature and MIT App Inventor
Thank you
In fact I need more than temperature and I use ESP_01
Is there a library support ESP8266 in avr codevision
What I need is very simple. I just want to send a string from atmega8 and resieve it on android
ESP8266,ATmega8,Temperature and MIT App Inventor
my project is Atmega8 connected to :
1-ESP8266 module by using serial port.
2-LM35 temperature sensor connected to ADC port
also I want to build a simple android app using MIT App Inventor to connect directly to wifi ESP module and show...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.