Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes I used 115200
that worked before I update,
also tried 9600 after the update but it didn't show anything.
this is the tutorial I followed up to update, at the end he said that if I didn't get anything then the firmware isn't suitable for the module and I should try another firmware, but I...
I have this esp8266 module, and I've updated the firmware to at 1.7 and now I can't get any AT command to work.
when I type any AT commands in serial monitor nothing shows up.
The at version that was on the esp before I update was 1.2.0.0 and I can't find this version anywhere.
the version I...
If I have many devices that uses nrf24l01 module to communicate to each other ( 3 arduino with sensors and nrf24l01 - and 1 to receive all this sensor's data ).
I want to create nrf24l01 module library in proteus. And I was asking If I will need nrf24l01 chip's footprint?
I will connect it to arduino to do some simulation. I don't need a pcb layout design.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.