Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply,
But this page only defines what is setup & hold time.
It doesn't defines on what parameter both of this timing depends..?
According to my logic: I think setup time depends on the driver strength & hold time depends on the delay of the capture flop...
Hello all,
Suppose I am having a D flip flop.
Now what are the parameters those affects the setup and hold time of the same?
If I want to change it, how to change it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.