Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I think you misunderstand what I mean, I dont wanna change my current source's circuit, I hope I can change the output signal of the source which is flat and constant to a square wave.
I have a CMOS accurate constant current source (1mA), now I wanna it be a square wave, maybe 50% duty is fine, what kind of CMOS circuit I can use to change it ?
Thanks for your reply, my question doesnot match with these documents, I mean, my main frequency is very low, 50Hz, and these documents are good for the high Frequency AC input. I know this, and I just want to know, did anyone do the low frequency 50Hz 220V AC plannar Tranformer?
I want to design a 220V 50Hz AC to 5V AC current is around 5mA~10mA PCB planner Transformer.
The efficiency is just more than 10%, that is enough.
Here is the question ?
1 Can I design it? Did anyone design this? Because the winding N is around 45:1. I think it will be not easy, but my...
I am a chip designer. I have some questions about power converter.
Now I want to use a simple device to convert the 220Vac to a low DC (1~3V current is around 10mA). The efficiency demand is not very high, more than 10% is OK. I want to design this power supply to a chip.
First idea is to...
thanks, i know your mean, but i asked why it has to be like that, for example, why the sin signal frequency has to be the tone_bin/Nfft. and for NBW, why NBW=1.5/Nfft
%% Simulate the DSM in time
Nfft = 2^13;
tone_bin = 31; what is tone_bin?
t = 0:Nfft-1;
u = 1*(nLev-1)*sin(2*pi*tone_bin/Nfft*t); why the input signal has to be this, what this means
v = simulateDSM(u,Ha,nLev);
figure()
n=1:1000;
plot(t(n), u(n), 'g');
hold...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.