Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You are right, in both C32 and XC32 , there exists 2 set of library headers, eg: UART.h and UART_legacy.h
So, to my previous question then,
No, compiler choices (C32 or XC32) don't matter and code will compile in both as they support the same APIs. :-D
Long story short, I was looking for a pdf of PIC32 peripheral libary for XC32 compiler because that was what I installed. Then I found out that Microchip didn't make pdf anymore, instead they put CHM files in the pic32-lib-help directory.
Ok, that's fine, but I notice the APIs are different from...
Hello,
I cam across a video on you tube,
Ratiometric config with RTD
and this video is from TI by the way :
In the video, the lecturer says the ADC_Dout= Vin * Gain * 2^24 / (2 Vref). I believe this is incorrect, it should be just Vref , am I right ?
Thank you !
Hello,
Upon testing my new 475 Tek scope, I noticed that XY mode figures are displayed off to the right side instead of the center. When adjusting X signal vertical position, I was able to move the figure back to the center but that would mean the X signal is off center when viewed in normal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.