Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I was wondering if it is possible to define a noise voltage spectral density for shot-noise:
The noise current spectral density of a semiconductor device exhibiting shot-noise is defined as: i^2=2qI, where q is the elementary charge.
Would it be possible to calculate the corresponding noise...
Hi, in Feko I would like to feed a planar antenna like a bow-tie sitting in a finite thickness substrate. I get errors at the beginning of the simulation either if I use edge port or wire port, basically the problem is that since the thickness of my metallization is infinitesimal the port...
Hi!
I simulate a 1 port dipole antenna in CST, I generate a .s1p touchstone file and I import it as a data item in a schematic of Keysight ADS. In ADS I connect the only port I have to a transistor, and I would like to 'radiate' or feed my antenna with some power coming from a power/voltage...
Hi all,
I have a doubt regarding the waveguide port: you can place a waveguide port in the 3D representation, then in the schematic you can see a pin coming out from your structure and this represents the waveguide port, but in the schematic representation. So in the schematic can I connect...
Hi all,
I am trying to optimize input and output impedance for a balanced diode frequency doubler and I am determining those impedances through a balanced circuit with 3 and 3 diodes in ADS as shown in the picture.
I need to match my 3D structure in CST to present the optimal input (first...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.