Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi.. i have made a ckt using atmega8 for 16*2 lcd .. there is no error shown in code in winavr..but while i run it in proteus 8 nothing is displayed on lcd..it is also not showing any error...plz help ..i am beginner.. :-(
here is my code.
.
this is pcb layout.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.