Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
also I it would be best if I could show the results of the PSD plots as a smooth line by putting some kind of line of best git through the pwelch values obtained.
Any advice on the above 2 questions will be much appreciated since I have to find a way of doing this in to show my results by the...
Hi,
I am simulating vibrations in simulink and processing my results in matlab. I am trying plot the PSD for my acceleration results using pwlech method.
When I plot the PSD plots from the methods below
(NOTE:I have a sampling rate of 0.006 so that means I am using a sample frequency of...
I am modelling the vibration of a 2 D.O.F system with damping in Simulink.
I want to set up control such that if the control value is between two values (max and min) then it sets the control value to the specified input but if it is outside the max and min interval then the control value is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
