Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am not at my home here I have no tools for analysis. Components values are standard instead of exact. Also as I said my input connected to a 3 meter coaxial cable with an anttenna and output connected to a digital receiver device so I don't know impedance or capacitance of out or input!!!
Hi guys, I am back.🙃🙃🙃 I want to filter above 900 Mhz and below 400 mhz UHF band with a band pass RC filter for a very noisy place, but for some reason it doesn't work, my values was two 100ohm resistor, one 1.8pico cap and one 3.8pico cap. I choose resistor value to 100 ohm because coaxial...
Physical layout is 100% correct just it's not clear exactly like schematic. I didn't use pot and voltage meter panel but Still that are correct microammeter is connected to resistors.
As I said I am not familiar with circuit designing but still I can make simple circuits.
they said it's wrong and go learn, but I know it's not a common circuit but It's working it can detect sources from 1 meter so it's a noise or RF I don't know!
I think it's clear for me, but if you think my circut is a mess then how it can work, if my resistors does nothing then I can remove them!!! Can you explain me how it's working?
Thank you for your advice. I am always learning but it doesn't mean I don't know anything.
It's not a mess. Resistors are essential for my circuit, without them it's not working so there is some function.(one opamp is enough but second one makes it more sensitive).
It's a detector so I can...
Hi guys here is my RF Detector circuit. I am not familiar with circuit designing but I could make it and it's working, it can detect Cell Phone radiation maybe GSM band and a little bit WiFi also electromagnetic waves from power sources and AC lines.
What do you think about it?
Can I improve it?
I know about it but geiger tube are only for gamma and x-rays. I heard about some of RF circuits that they can detect gamma rays also so I think it's possible without giger tubes.
Exactly that's why I am here.
I know it's uncommon but my information is so much lower than you that's why I asked here for finding an answer. It's possible or not.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.