IanP
Advanced Member level 5
Find latest posts
View Articles
View Blog EntriesMini Statistics
- Join Date
- 5th October 2004
- Last Activity
- 18th May 2016 15:27
- Blog Entries
- 0
More 60 Friends
Awards
No Awards.
Achievements
7 years registered- Tab Content
- IanP's Activity
- About Me
- Friends
- Experience
-
Older Activity
-
22nd January 2020, 05:17thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsSir, Now cleared the doubts learned charactrestics lot of . And I Concluded that the desgin as follows . VDD =12Volt ...21 replies | 1775 view(s) -
18th January 2020, 08:43thannara123 replied to a thread ADC Value gets changed when a Digital output enables in Power Electronicselectrical noise may lead ADC value2 replies | 344 view(s)
-
17th January 2020, 17:17thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsHai sir i don't have confusion as you said . I know ohmic or linear or triode region is the low resistance mode of the MOSFET operation. Where the...21 replies | 1775 view(s)
-
17th January 2020, 12:01thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsThanks , But then Is the MOSFET works on cutoff and Ohmic region ? or cutoff and stauration region?21 replies | 1775 view(s)
-
17th January 2020, 04:38thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsHow can i attain in ohmic / Triode region ? As per the data sheet The Vds should be in the range of 2.5volt for the ohmic region. and Vgs is 5volt...21 replies | 1775 view(s)
-
16th January 2020, 15:49thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power Electronicsconfused a little :-? Mesuare the Vds when it ON it gives 12mv and 10.5mv for V1 =12v and V1 = 10 respectively .21 replies | 1775 view(s)
-
15th January 2020, 17:40thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsAnd Comonly what type of protections are required for a MOSFET.21 replies | 1775 view(s)
-
15th January 2020, 15:29I am intrested :thumbsup:11 replies | 994 view(s)
-
15th January 2020, 14:53thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsIf Vgs is 11volt and Vds is 10 volt it saying that Ohmic region . As per the ohmic and saturation region the plots shows no diffrents why so . ...21 replies | 1775 view(s)
-
11th January 2020, 13:41thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsThen is correct My aproximation?21 replies | 1775 view(s)
-
11th January 2020, 12:59thannara123 replied to a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsConsider this only for learning purpose . I am Choosing N Channel MOSFET 90NF03L https://www.st.com/resource/en/datasheet/stp90nf03l.pdf As...21 replies | 1775 view(s)
-
11th January 2020, 04:49thannara123 started a thread Require a Desgin of A MOSFET based Switch , for study purpose . in Power ElectronicsI am stauding the MOSFET caharcterstics , May I get a Desgin for a MOSFET based Switch for ON and OFF . with least resistance and maximum...21 replies | 1775 view(s)
-
10th January 2020, 13:45thannara123 replied to a thread [SOLVED] Technique behind the Charging and Inverting Function of an Inverter in Power ElectronicsIt charges ,The Boost coil is the secondary of the Transformer ,That is the Tehniuqe6 replies | 604 view(s)
-
7th January 2020, 17:33thannara123 replied to a thread [SOLVED] Technique behind the Charging and Inverting Function of an Inverter in Power ElectronicsI find out the answer from the thread following https://www.edaboard.com/showthread.php?262078-h-bridge-boost-charging-at-constant-current It...6 replies | 604 view(s)
-
7th January 2020, 16:17Hello Can you suggest some of MCU for the same project s. Thanks6 replies | 837 view(s)
-
6th January 2020, 15:25thannara123 started a thread [SOLVED] Technique behind the Charging and Inverting Function of an Inverter in Power ElectronicsHello , I have an inverter, In which has a H-bridge connected to a low frequency Transformer (230volt /7.5 volt) . Here the Inverting function...6 replies | 604 view(s)
About IanP
Basic Information
Optional Info
- Location:
- West Coast
Statistics
Total Posts
- Total Posts
- 7,942
- Posts Per Day
- 1.42
General Information
- Last Activity
- 18th May 2016 15:27
- Join Date
- 5th October 2004
Helpful Postings
- Has Rated
- 111
- Post Rated
- Rated helpful 2307 out of 2307 times
60 Friends
Showing Friends 1 to 10 of 60
Experience
Points
- Points
- 74,061
- Level
- 66
Level up completed
- Level up completed
- 40%
- Points required
- 1,389
Activity
- Activity
- 0%
- Activity last 30 days
- 0%
- Activity last 7 days
- 0%
Points
All Points for user
- Points for User
- 38,798
- Points for Reputation
- 36,467
- Points for every day since registration
- 2,146
- Points for Friends
- 180
- Points for filling profile
- 5
All Points for threads
- Points for threads
- 47
- Points for Threads
- 14
- Points for replies
- 33
All Points for posts
- Points for Posts
- 35,216
- Points for Posts
- 23,761
- Average Posts per Day
- 1.00
- Helpful Answers
- 11,455
All Points for miscellaneous
- Points for Misc
- 0