Whats's the purpose of feedback resistor in your simulation circuit? If it's DC bias, the feedback path should be filtered in a way that it doesn't ruin
FvM Yesterday, 23:12Charging VR450 continuously with 20 mA will not quickly damage it but probably reduce its lifetime by overcharging it. Continuous current without voltage
FvM Yesterday, 23:05Firstly, is it integrated or not? Integrated mixer's input is connected to a low noise amplifier (LNA) usually, matching between them is not necessary
frankrose Yesterday, 22:56You have an OTA with a feedback. The GBW is the frequency where the loop gain crosses 0dB. The same GBW frequency is the -3dB frequency of the closed
sutapanaki Yesterday, 21:30
Re: Confusion with relating the sensor output voltages from its datasheet
I agree that the datasheet is very clear about expectable output voltage.
FvM Yesterday, 23:23But if you plan to measure 500 ug acceleration, you should carefully