EDABoard Articles and Tutorials - sarine

Section Widget
Categories Widget (Show All)

First_ > First_ (0)
Recent Articles

sarine

There is no available content written by sarine

Recent Article Comments Widget
Recent Blog Posts
Recent Forum Posts

Re: Confusion with relating the sensor output voltages from its datasheet

data sheet page 3:

Sensor Input Measurement range (typical) +/- 3.6g

Sensitivity (typical) 300 mV/g

Zero
wwfeldman Today, 15:09

Re: problem with coding 123

Hi,

to adjust to DAC digital input range --> and thus it´s analog output range to full scale...

Klaus
KlausST Today, 15:03

Re: problem with coding 123

... and what is the point in multiplying the result by 4? It is still a 10-bit value with zeroes at the end. It may be stored with extra bits but the
betwixt Today, 14:58

Confusion with relating the sensor output voltages from its datasheet

From the datasheet of this acccelerometer I cant figure out the x y z outputs' voltage ranges. Is it mentioned in the datasheet what output voltages corresponds
floppy32 Today, 14:42

Sequential ATPG errors that dont go away because of hardware metal faults

suppose you had a metal line. Current metal lines are about 22nm. There are about 22000 atoms in 22 nm since an atom is about 1 pm. Now, spectral atpg
firewireblue Today, 14:40

All times are GMT +1. The time now is 16:06.

Powered by vBulletin™
Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.

vBulletin Optimisation by vB Optimise.