• Section Widget

  • Categories Widget (Show All)

  • Recent Articles

  • dick_freebird

    There is no available content written by dick_freebird
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    FvM

    Re: Two Qs re: resistance

    Where did you get 5.3k? Resistance of parallel circuit is 10*4.7/(10+4.7) = 3.2k.

    FvM Yesterday, 23:54 Go to last post
    FvM

    Re: Wrong simulation for VP0808 mosfet?

    Do you understand the meaning of Vgs(th) specification in datasheet, particularly the wide threshold voltage range?

    FvM Yesterday, 23:43 Go to last post
    FvM

    Re: Metastabilty and data loss

    The OP apparently doesn't care for consistency of multibit data. I already asked about this point and he insists on discussing correctness of single

    FvM Yesterday, 23:14 Go to last post
    sutapanaki

    Re: Two Qs re: resistance

    If the two resistors have one terminal in common, then it is series connection and current will reduce if the voltage across the series connection stays

    sutapanaki Yesterday, 23:04 Go to last post
    riffwraith

    Two Qs re: resistance

    Not sure if the answer depends on the circuit, or if this is a rule that will apply across the board?

    So, I get that a resistor will limit

    riffwraith Yesterday, 22:56 Go to last post