• Section Widget

  • Categories Widget (Show All)

  • Recent Articles

  • dpaul

    There is no available content written by dpaul
  • Recent Article Comments Widget

  • Recent Blog Posts

  • Recent Forum Posts

    TheDannia

    PWM Ramp Voltage of SG3525

    Hi,

    I'm trying to calculate a feedback compensator for SG3525 IC. I need pwm ramp voltage for this IC but it's not given in datasheet.

    TheDannia Today, 13:29 Go to last post
    mtwieg

    Re: Localizing acoustic noise source on PCB

    I'll give airline tubes and acrylic rods a try today, thanks. Unfortunately, the board has to be mounted inside a chassis, where there's no room for large

    mtwieg Today, 13:15 Go to last post
    carpenter

    How "repair" voltmeter gauge?

    I have automobile voltmeter gauge , on the scale is indicated 8 - 16V.
    Unfortunately it is damaged and so shows at these voltages. Gauge is inseparable.

    carpenter Today, 12:53 Go to last post
    ziko0707

    Re: cooler master silent prp 500w pc psu

    About small cap, PSU was 7-8 days old, then was thunderstorm and I opened to see if just fuse blow, because was weekend time. Then my guaranty goes away

    ziko0707 Today, 12:52 Go to last post
    stenzer

    Re: Class AB amp output signal

    Hi,

    the AB amplifier is biased to combine linearity/ sound quality of an A-class amplifier and the efficiency of a B-class amplifier. The

    stenzer Today, 12:32 Go to last post