Proteus Ares Power Plan question

  1. yvesmichel
    yvesmichel
    Hello all,
    I'm using a Licence Ares version Proteus 7.9. I'm designing a circuit board with Ares. I'm not using he Isis schematics do it as there was not enough components I wanted.
    The problem is by doing so I cannot create a Power Plan on the soldering side that has the gaps between the pads and tracks. Another reason I'm not using Isis schematic is because it doesn't let me do free hand tracing. If I could connect a pad to the Power Plane(ground) it will be fine. Is there anyways around this?
    Many thanks,

    Regards to all
Results 1 to 1 of 1