Hi everyone!
I am new to simulating with HFSS and I am using the Ansys Electronics Desktop 2019 R1 version.
I have as a project to simulate (and fabricate) horn antenna. As far as I have seen I am following the correct steps for the simulation, but I keep getting the following error.
[error] Port refinement, process hf3d error: Too few conductors were found on port 1. There should be one conductor for each terminal, with one additional reference conductor. Unintentional contact between conductors may cause this error.
I have read in a couple of forums that it is a problem with the port reference assignment, but the explanations are not clear enough on how to solve it.
I am new to simulating with HFSS and I am using the Ansys Electronics Desktop 2019 R1 version.
I have as a project to simulate (and fabricate) horn antenna. As far as I have seen I am following the correct steps for the simulation, but I keep getting the following error.
[error] Port refinement, process hf3d error: Too few conductors were found on port 1. There should be one conductor for each terminal, with one additional reference conductor. Unintentional contact between conductors may cause this error.
I have read in a couple of forums that it is a problem with the port reference assignment, but the explanations are not clear enough on how to solve it.