pcpro178
Newbie level 1
- Joined
- Jun 16, 2011
- Messages
- 0
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,280
- Location
- Wisconsin, USA
- Activity points
- 1,280
I have a ZigBee 2006 Home Automation network for which I am developing a new End Device. My question is if an End Device joins a network and then later again attempts to join the same network, should that work? My End Device previously joined the network, but it was then power-cycled for development/debug purposes. Nothing is stored in non-volatile memory on the End Device, so it forgets all about being part of a network when it is power-cycled. When I try to get it to rejoin the network, I see a lot of Association Requests in my Ubiqua ZigBee sniffer, but the network never responds. The only reason I can think of for this is that I may have used up all the short addresses. Are there any other reasons this may be happening? Thanks.