Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Bad layout board for DC-DC also makes line and load reg not good. As you know, DC-DC will creat much noise, heavier load more noise. Then if Ground inside chip and Ground for Vout outside are different from each other because of layout board. It will make load and line reg bad
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
