ApTuPr
Junior Member level 1
Hello Folks
I am doing physical designing of ARM Core M0. I have two doubts:
1. Where to place special cells- End cap, well tap and Tie cells. May I know how and where to place them? Though I have theoretical idea but don't know after which step (floorplann, PnR, etc.) this should be done.
2. I am using Innovus, what is the command for placing these cells?
Hope to get reply soon
Thanks in advance
I am doing physical designing of ARM Core M0. I have two doubts:
1. Where to place special cells- End cap, well tap and Tie cells. May I know how and where to place them? Though I have theoretical idea but don't know after which step (floorplann, PnR, etc.) this should be done.
2. I am using Innovus, what is the command for placing these cells?
Hope to get reply soon
Thanks in advance