Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Signal integrity analysis in Altium designer

Status
Not open for further replies.
V

viperpaki007

Full Member level 5
Joined
Jul 2, 2008
Messages
270
Helped
11
Reputation
22
Reaction score
8
Trophy points
1,298
Location
Finland
Activity points
3,395
Hi,

I want to run a signal integrity analysis in Altium designer. I have never done SI analysis before. My question is: How can i define the input source for SI analysis? For example, normally in PCB the inputs are connected to a connector and i cant find any input source model for a connector in altium designer. I get error..SI not performed because net contains a connector.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top