Rectifier

[khatus]

I am trying to simulate the below circuit in proteus simulator. It is a circuit to make rectifier (AC to DC) using OP AMP but the problem is in the output, the rectified output (yellow line) is not coming in the oscilloscope. Can anyone simulate this circuit in proteus?

 

[FvM]

Unfortunately the simulation schematic is hiding many important details, e.g. absolute level of input voltage, supply voltages, OP model. Text "741" doesn't clarify if it has an attached simulation model, same with the diode.

 

[danadakk]

Not proteus but here is what it should look like :

Regards, Dana.

 

[KlausST]

Hi,

the yellow signal should be visidble.
Delete both scope inputs.
Then wire each one that it goes out horizontally (not vertically as your B channel does)

Klaus