Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Pulse Width measurement

Status
Not open for further replies.
B

babyeric

Junior Member level 1
Joined
Dec 21, 2007
Messages
18
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,469
Hi,

I have a BPSK signal without encoding with Bit Rate = 256kbps, so my BW will be 256kHz. Assuming I'm sending my signal on a packet basis, and 1 packet contain of 100bits/symbols. So can I say that my signal pulse width is

100/BW?

Hope can get some advice..Thank you so much. =D
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top