Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear all
Would like to know the preheat time of NAP-55A gas sensor from nemotos corporation. could anybody please help me to find the answer for this.?
Reading Nemoto web information carefully, you'll be aware of this general statement about catalytic sensor usage
•Not like semiconductor type sensors, a long preparatory aging time is not necessary for performance stabilization.
•In case of gas detector applications, aging for 10 minutes would be enough before calibration. Calibration can be done in air without a test gas.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
