Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MPC7410 flashing issue - my code is not downloading to flash

Status
Not open for further replies.
M

mohd_ind00

Junior Member level 3
Joined
Dec 17, 2004
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
269
28f640j3 codewarrior

Dear All,

I have used MPC7410 PPC in my design along with TSI107. My boot flash(28F640J3) is residing on RCS0# of TSI and the data flash(28F128J3) on RCS2# of TSI. SDRAM is interfaced to TSI_CS0#. Hence there is no direct SRAM on the MPC7410 data bus.

Now i am trying to flash my code through codewarrior IDE by setting flash address. But my code is not downloading to flash.

Is it the right way i am doing?

OR

I need a scratch pad SRAM interfaced directly to MPC7410 to enable the codewarrior to load flash drivers to a SRAM temporary loacation. does this must?

OR

by any other way i can do this?

Please clarify these doughts?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top